6
5. Insert the bulb into the housing, and turn the tool handle
right
to tighten the bulb.
6. Insert the new bulb into the housing, and twist
right
to
tighten it.
7. Remove the suction cup, and turn the power ON at the
fuse box or circuit panel.
Replacement Parts
Order at www.everythingdacor.com
Dacor hoods use either baffle or mesh filter types. Contact
Dacor customer service for assistance/information concern-
ing the filter types.
This table shows the model numbers and descriptions of the
available filter types:
Model #
Description
AWHBF2/3/4 Baffle filter for RNHP/E hoods: 30” (2
filters); 36” (3 filters); 48” (4 filters)
AWHMF2/3/4
1. (To avoid damaging the appliance’s electrical system
should a short occur) Turn the power OFF at the circuit
breaker or fuse box.
2. Wipe the bulb lens clean, then gently press the suction-
cup tool (included with the hood) onto the lens.
3. Turn the tool handle
left
to loosen the bulb, then remove
the bulb from the housing.
4. Attach the suction-cup tool to the lens of the replace-
ment bulb.
Care and Cleaning
Maintenance
Cleaning the Stainless Steel
• Clean stainless steel surfaces with a mild solution of dish-
washing liquid and warm water, always wiping
with
the grain.
(For best results, Dacor recommends you use Dacor Stain-
less-Steel Cleaner, according to package directions).
• Do not clean with abrasive cleaners or abrasive cloths.
• Rinse and dry with a micro-fiber or other soft, lint-free cloth.
Replacing the Light Bulbs
The homeowner performs this task. Before replacing any
bulbs (or if any light does not work), verify that power is ON
at the circuit breaker, fuse box, light swich, or main power
switch (
Removing the Filters
, Pg. 5).
Dacor Part #
Description
702666
Dimmable LED Bulb Replacement Kit
(1 bulb + 1 suction cup tool)
702579
Baffle Filter Kit (1 pc + hardware)
702580
Baffle Filter Kit (2 pc + hardware)
WARNING
• To prevent electric shock, turn power OFF at the fuse
box or circuit breaker panel, then replace the light bulb.
• To avoid risk of fire, do not use light bulbs stronger
than 7.5W LED or 75W, 120V Halogen.
• To avoid personal injury, ensure the hood and the
light’s lens are cool before changing the light bulb.
• To avoid system damage and faulty performance, use
only dimmable bulbs.
NOTE
If the bulb does not engage, ensure the new bulb’s lens
is clean, then repeat Steps 4 and 5, being sure to insert
the bulb fully into the housing.
TIP
If buying your own bulb, take the old bulb to the store
as reference, or use these specifications: Dimmable
LED 7.5W (max) or Halogen 75W (max), 120V; PAR16,
E26/27, 500 lumens.
