Dacor RF36NDFSS, Use And Care Manual

Page: 6 / 32

4
Sabbath Mode (SAB)
IMPORTANT: This preference does not disable interior lights.
ON - All control panel lights will be disabled.
OFF - All control panel lights will be enabled.
NOTE: Press any touch pad on the control panel to restore the
control panel lights.
To Access the User Preferences Menu:
1. Press and hold the Door Alarm touch pad for 3 seconds. The
preference name will appear in the Freezer display and the
preference status (F or C) or (ON or OFF) will appear in the
Refrigerator display.
2. Use the Freezer or touch pads to scroll through the
preference names. When the desired preference name is
displayed, press the Refrigerator or touch pads to
change the preference status.
3. Set your preferences by pressing and holding the Door
Alarm touch pad for 3 seconds, or by shutting the refrigerator
compartment door.
Crisper Humidity Control
You can control the amount of humidity in the moisture-sealed
crisper. Adjust the control to any setting between Low and High.
Low is best for storage of fruits and vegetables with skins. High is
best for storage of fresh, leafy vegetables.
Water Filtration System
The water filter is located in the upper right-hand corner of the
refrigerator compartment.
Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after
the system. Systems certified for cyst reduction may be used on
disinfected waters that may contain filterable cysts.
Water Filter Status Lights
The water filter status lights will help you know when to change
the water filter. When the order light is on, it is almost time to
change the water filter. When the replace light is on, a new water
filter should be installed.
After replacing the water filter, press and hold Filter Reset for
3 seconds until the yellow or red light turns off. See Setting the
Controls on page 3.
IMPORTANT: The disposable water filter should be replaced at
least every 6 months. If the water flow to the water dispenser or
ice maker decreases noticeably before 6 months have passed,
replace the water filter more often.
Refrigerator Operation
Setting the Controls (continued)
Temperature Alarm
The temperature alarm feature provides temper-
ature information in the event of a power outage.
Power outage: During a power outage, if the temperatures in the
refrigerator and freezer compartments exceed normal operating
temperatures, the highest temperature reached will be displayed.
„
Press the Temp Alarm touch pad until the indicator light is
lit, to turn on this feature. Press and hold Temp Alarm for 3
seconds until the indicator light goes off to turn off this feature.
Temperature alarm: An alarm will sound repeatedly if the
freezer or refrigerator compartment temperatures exceed normal
operating temperatures for an hour or more.
The temperature displays will alternately show the current temper-
atures and the highest temperatures the compartments reached.
„
Press the Temp Alarm touch pad once to stop the audible
alarm and alternating temperature displays. The Temp Alarm
light will continue to flash until the refrigerator returns to the
set temperature.
Door Alarm
The door alarm feature sounds a chime every few
seconds when the refrigerator door has been left
open for 5 continuous minutes. The chime will sound until the
door is closed or the door alarm is turned off.
„
Press the Door Alarm touch pad to turn this feature on or off.
The indicator light will be lit when the feature is on.
Max Cool
The max cool feature assists with periods of high
refrigerator use, full grocery loads, or temporarily
warm room temperatures.
„
Press Max Cool to set the freezer and refrigerator to the
lowest temperature settings. Press Max Cool again to return to
the normal refrigerator set point.
NOTE: The max cool feature will automatically shut off in
approximately 12 hours.
Filter Reset
The filter reset feature allows you to restart the
water filter status tracking feature each time you
replace your water filter. See Water Filtration System .
„
Press and hold the Filter Reset touch pad for 3 seconds, until
the order or replace light turns off.
User Preferences
The control center allows you to set user preferences, if desired.
Temperature Display (F_C)
This preference allows you to change the temperature display.
F - Temperature in degrees Fahrenheit
C - Temperature in degrees Celsius
Alarm (AL)
This preference allows you to turn off the sound of all alarms.
ON - You will hear the alarm sound.
OFF - You will not hear the alarm sound.