9
Installing the Anti-Tip Bracket
Locate the anti-tip bracket included in the parts box.
There are two ways to mount the anti-tip bracket:
•
Floor mounting (preferred method)
•
Wall mounting (alternate method). Use this method if
floor mounting is not suitable. If any of the conditions
below exist, then the wall mounting method can not be
used and the floor mounting method must be suitable.
The anti-tip bracket may not be mounted to the wall if:
◊
The wall contains metal stud mounting materials that
interfere with the anti-tip bracket mounting screws.
◊
The front panel of range is further than the maximum
distances from the back wall stated on page 11.
◊
The flooring is too thick (see
Installing the Anti-Tip
Bracket on the Wall
).
Installing the Anti-Tip Bracket on the Floor.
WARNING
To perform its intended function, the anti-tip bracket
must be attached as instructed to the concrete slab
or wood sub-floor below any floor coverings (including
cement board) on top. Do not attach the anti-tip bracket
directly to floor coverings such as ceramic/asphalt tile or
linoleum.
continued...
Verifying the Package Contents
Unpack the range and verify that all required parts have
been provided. If any item is missing or damaged, please
contact your dealer immediately. Do not install a damaged
or incomplete appliance. The customer must report
cosmetic issues immediately to the dealer or builder.
Parts List
•
Anti-tip bracket with screws and anchors
•
2 grates
•
Use and care manual
•
Stainless steel cleaner
•
1 dual burner ring
•
1 outer dual burner cap
•
1 inner dual burner cap
•
3 standard burner caps (2 large, 1 small)
•
3 standard burner rings (2 large, 1 small)
•
2 oven racks
Installation Instructions
WARNING
•
If the gas or electric service provided does not meet
the product specifications, do not proceed with the
installation. Call the selling dealer, the gas supplier or
a licensed electrician.
•
This appliance must be installed by a licensed
plumber or gas fitter when installed within the
Commonwealth of Massachusetts.
Gas and Electrical Locations
•
Dacor recommends that utility access for all models
be installed in an adjacent cabinet, as shown on page
6. If the utilities are installed behind the range, the
installation must allow for the following:
◊
Access to the gas shut-off valve when the unit is
installed.
◊
Access to the electrical outlet, when the range is in
place.
◊
The gas supply piping, gas shut-off valve and the
electrical outlet must be located so they do not
interfere with the range when it is installed.
◊
The electrical outlet and gas shut off valve must
be located so that the range can be pulled out for
service while the appliance remains connected.
•
Both the gas supply piping and shut-off valve and the
electrical outlet must be located so they do not interfere
with the range when it is installed.
CL
CL
10” (25.4 cm)
10” (25.4 cm)
12” (30.5 cm)
2 1/2”
(6.4 cm)
3 1/2”
(8.9 cm)
1” (2.5 cm)
•
Existing utility connections may be used for
replacement purposes, provided they meet local code
and fit within the utility clearance area at the back of
the range. See diagram, below.
Installation Specifications
Utility Clearance
Behind Range
