DAB GENIX VT Series, Instruction For Installation And Maintenance

Page: 12 / 148

ENGLISH
GB
12
3.3 Unscrew the screws of the board holder.
3.4 Remove the pressure switch pipe.
3.5 / 3.6 Clean the rubber hose and check the opening on the tank.
Foreign body in tank
1.1 Disconnect the power supply
3.1 Unscrew the screw of the motor cover and remove the cover
3.2 If the water level is above the motor flange, empty the tank by means
of the appropriate tap and the hose (supplied).
4.1 Unscrew the side screw of the motor ring
4.2 Lift the motor flange to reduce the compression of the O-ring. Insert a
screwdriver into the notch underneath the supply cable and press it down.
4.3 Extract the complete motor unit by means of the handles (lift the unit
vertically before tilting it).
4.4 Check and clean the tank and impeller/grinder.
Carbon filter
5.1 Remove the filter cover
5.2 Replace the filter
The carbon filter should be replaced once a year to ensure sufficient
filter function.
Instead of using the activated carbon filter, the system can also vent
through a vent pipe with diameter 20.
7. TECHNICAL DATA
Model Hz
Volt
(V) P1 (W)
Amp
(A)
Cos ᵠ
Hmax
pump
(m)
Flow
max
(m3/h)
Genix VT 50 220-240 530 2.5
0.95
0.91
8.0 7.8
• Supply voltage: see electrical data plate
• Grade of motor protection: IP44
• Protection rating: F
• Noise level: <70dB(A) to EN 12050-3
• Delayed line fuses (version 220-240v):
indicative values (Ampere)
• Duty:
S3 -50% 1min. (30 sec on; 30 sec off).
• Ambient temperature:
da +5°C a +35°C
• Start and stop levels:
Start: 72 mm above bottom
Stop: 52 mm above bottom
The system pressure should not exceed 6 m head to guarantee a
sufficient drain of the connected sanitary appliances (see rapid
guide).
• Storage temperature:
-10°C +40°C
• Marking:
8. MANAGEMENT
8.1 Storage
All the pumps must be stored in a dry covered place, with possible con-
stant air humidity, free from vibrations and dust.
They are supplied in their original pack in which they must remain until the
time of installation.
8.2 Transport
Avoid subjecting the products to needless impacts and collisions.
8.3 Weight
The adhesive plate on the packaging indicates the total weight of the pump
9. MODIFICATIONS AND SPARE PARTS
Any modification made without prior authorisation relieves the
manufacturer of all responsibility. All the spare parts used in re-
pairs must be authentic and all accessories must be authorised
by the manufacturer, in order to ensure maximum safety of the
machines and of the systems in which they may be installed.