DAB PUMPS MCE-22/P, Instruction For Installation And Maintenance

Page: 89 / 1085

ENGLISH
86
Quick-view menu (visible) Full Menu (direct or password access)
Main menu User menu
mode
Monitor menu
set-minus
Setpoint menu
mode-set
Manual menu
set-plus-minus
Installer menu
mode-set-minus
Tech. Assist.
menu
mode-set-plus
MAIN
(Main page)
FR
Minimum
of rotation
VF
Flow display
SP
Setpoint
pressure
FP
Minimum
Frequency mode
RC
Current
frequency
TB
Block time
due to water failure
Menu selection VP
Pressure
TE
Dissipator
temperature
P1
Aux. 1 pressure
VP
Pressure
RT
Direction
of rotation
T1
Shutdown time after low
pressure
C1
Pump phase
current
BT
Card
temperature
P2
Aux. 2 pressure
C1
Pump phase
current
FN
Rated
frequency
T2
Delay on shutdown
PO
Power delivered to the
pump
FF
Fault & Warning
Log
P3
Aux. 3 pressure
PO
Power delivered to the
pump
OD
Type
of system
GP
Integral
gain
SM
System monitor
CT
Contrast
P4
Aux. 4 pressure
RT
Direction
of rotation
RP
Restart
Pressure decr.
GI
Integral
gain
VE
HW and SW
information
LA
Language
VF
Flow display
AD
Address
FS
Maximum
frequency
HO
Operating hours
PR
Pressure sensor
FL
Minimum
frequency
MS
Measurement system
NA
Active inverters
FI
Flow sensor
NC
Max. simultaneous
inverters
FD
Pipe diameter
IC
Inverter config
FK
K-factor
ET
Max. exchange time
FZ
Zero flow frequency
CF
Carrier
FT
Min. flow
threshold
AC
Acceleration
SO
Dry running factor
Min. threshold
AE
Antiblocking
MP
Min. dry running
pressure
I1
Input 2
function
I2
Input 2
function
I3
Input 2
function
I4
Input 2
function
O1 Output 2
function
O2 Output 2
function
RF
fault & warning
reset
PW
Setting
Password
Key
Identification colours Modification of multi inverter unit parameters
Series of sensitive parameters. These parameters must be aligned to enable start-up of the multi-inverter system. Modification of one of
these parameters on any inverter will automatically align all other inverters without the need for any command.
Parameters that enable facilitated alignment from a single inverter, transferring data to all others. It is admissible that these differ
between inverters.
Series of parameters that can be aligned in broadcast mode by one inverter only.
Setting parameters significant on a local level only
Read-only parameters
Table 13: Menu structure