DAB PUMPS DIVER 6 1050 W, Instruction For Installation And Maintenance

Page: 6 / 21

ENGLISH
2
Model P1=540 W P1=830 W P1=1050 W
Electrical data P1 Rated absorbed power [W] 540 830 1050
P2 [W] 400 570 710
USA P2 [HP] Fractional (decimal) 1/3 (0.3) 1/2 (0.5) 3/4 (0.75)
Mains voltage [V] ~ 115-120V AC
Mains frequency [Hz] 60
Current [A] 5.5 7.9 9.3
Capacitor [µF] 30 35
Capacitor [Vc] 250
Hydraulic data Max. flow rate [gpm] 26.4
Max. head [ft] 78.7 114.8 150.9
Max. head [psi] 34.8 50.8 66.7
Max. immersion depth [ft] 39.4
Min. submersion height [in] 4.7
N. of impellers 2 3 4
Range of use Length of power cable [ft] 49.2
Type of cable SJTOW 16AWG
Grade of motor protection IP 68 / NEMA 6P
Insulation class F
Liquid temperature range [F]
according to EN 60335-2-41 for domestic use
+32 F / +95 F
Max. particle dimension [in] 0.04
Max. ambient temperature [F] 104
Weight DNM NPT 1'' F
Table 2
AdBlue versions may have specific technical data: check the technical label on the product.
The pump which does not stand on a base cannot support the weight of the pipes, which must be
supported in some other way.
4. MANAGEMENT
4.1 Storage
All the pumps must be stored in a dry covered place, with possible constant air humidity, free from vibrations and dust.
They are supplied in their original pack in which they must remain until the time of installation.
4.2 Transport
Avoid subjecting the products to needless impacts and collisions.
4.3 Weight and dimensions
The adhesive plate on the packaging indicates the total weight of the pump and its dimensions.
5. WARNINGS
The pumps must never be carried, lifted or allowed to operate suspended from the power cable; use
the handle and cord provided.
Before installation, dredge any sand and other solid particles from the cistern.
The motor’s power cord must be secured to the delivery pipe with plastic clamps every 2 or 3 m (6 or
10 ft).
Use the check valve provided.

The pump must never be allowed to run when dry.

The sealing device contains lubricant which is non-toxic but which may alter the characteristics of the water, in the
case of pure water, if the pump were to have any leaks.
6. INSTALLATION
The electrical system must be compliant with local norms.
Screw first the non-return valve and then the nipple using the connector ideal for ¾’’ and 1’’ pipes provided in the
packaging. If a pipe with greater diameter is to be used, change the connector. Use a pipe tightening clamp to secure the
pipe to the fitting Fig.1

It is advisable to use pipes having a minimum internal diameter of ¾’’, to avoid the decrease of pump performance.