2
Important Safety Instructions
When using your video equipment, basic safety precautions
should always be followed, including the following:
1. Read and understand all instructions before using.
2. Position the cord so that it will not be tripped over, pulled, or
contact hot surfaces.
3. If an extension cord is necessary, a cord with a current rating
at least equal to that of the appliance should be used. Cords
rated for less amperage than the appliance may overheat.
4. To reduce the risk of electric shock, do not disassemble this
appliance. Contact an authorized service dealer when repair
work is required. Incorrect reassembly can cause electric
shock when the appliance is used subsequently.
5. The use of an accessory attachment not recommended by
the manufacturer may cause a risk of fire, electric shock, or
injury to persons.
6. Failure to provide adequate structural strength for this
component can result in serious personal injury or damage
to equipment! It is the installer’s responsibility to make sure
the structure to which this component is attached can
support the weight of all equipment. Reinforce the structure
as required before installing the component.
7. Use this projection screen only for its intended use as
described in these instructions. Do not use attachments not
recommended by the manufacturer.
Save These Instructions
Original Instructions
Disclaimer
Legrand AV and its affiliated corporations and subsidiaries,
intend to make this manual accurate and complete. However,
Legrand AV makes no claim that the information contained
herein covers all details, conditions or variations, nor does it
provide for every possible contingency in connection with the
installation or use of this subject to change without notice or
obligation of any kind. Legrand AV makes no representation of
warranty, expressed or implied, regarding the information
contained herein. Legrand AV assumes no responsibility for
accuracy, completeness or sufficiency of the information
contained in this document.
Da-Lite® is a registered trademark of Legrand AV Inc. All rights
reserved.
Pre-Installation
1. Carefully unpack screen and remove outer wrapping from
case.
2. The slat retainer screws must be removed before installation.
Use supplied 1/8" nex key to remove silver shipping brackets
attached to slat and screen case. Orient the case with the
slat down and then remove the screws. The case must
remain in that orientation throughout the installation process
to avoid fabric damage.
