3
The Tensioned Large Cosmopolitan® Electrol® comes with brackets to allow for wall mount or ceiling mount installations.
Procedures for each method are as follows::
Wall Mount
1. Remove the four ceiling mount brackets from the wall mount
bracket.
2. The wall mount bracket should be fastened to wall studs or
some reinforcement within the wall. Concrete or brick walls
require special fasteners and anchors.
3. The wall bracket has holes spaced at 16" and 24" to align with
most wall studs.
4. The bracket must be level and plumb.
5. Keep in mind you will need at least 2-3/4" between the ceiling
and the top of the wall mount bracket to be able to position
the case on the bracket.
6. Mount the screen case on the wall bracket as shown in
figure 2. Be sure the case is fully seated on the bracket.
Tighten the stop screws against the wall bracket.
Ceiling Mount
1. Be sure the ceiling has adequate reinforcement to attach the
screen brackets.
2. The ceiling brackets are pre-attached to the wall mount
bracket using 5/16" x 3/4" bolts, washers and nuts. The
brackets can be adjusted within the ranges shown in figure 3.
NOTE:
All four ceiling brackets must be used when mounting
to the ceiling or suspending the screen.
3. Position the ceiling bracket assembly on the ceiling and
attach with 5/16" bolts (not supplied). The bolts should be
long enough to pass through the drywall or ceiling tile and
penetrate at least 1-1/2" into the reinforcement in the ceiling.
4. Mount the screen on the wall bracket as shown in figure 2. Be
sure the case is fully seated on the bracket. Tighten the stop
screws against the wall bracket.
Installation
Wall Mount
Bracket
Ceiling Mount
Bracket
Figure 4
Figure 2
Figure 1
Viewing Surface
(Audience Side)
Case Hook
Wall Mount
Bracket
Stop Screw
2
"
1 1/8"
Case Hook
Viewing Surface
(Audience Side)
Ceiling Mount
Bracket
5/16 x 3/4" Bolt
Nut and Lock
Washer
Wall Mount
Bracket
Stop Screw
