12
Ejecting Used/Misfired Power Load
1. After launch (or misfire), lift Locking Lever and open
Dummy Launcher.
2. Continue opening past normal stopping point.
3. Release and allow Launcher to go back normal stopping
point, and remove Power Load.
UNLOADING/EJECTING POWER LOAD
WARNING - Review the Safety Warnings on p.4 and
familiarize yourself with all Parts & Functions on p.8-9
before operating this launcher.
NOTE
- Clean the Launcher between each use with a .22
cal. cleaning brush and gun solvent.
TROUBLESHOOTING
•
If you are consistently getting misfires, try a new box of
power loads. Also, make sure you are pulling the Firing
Pin Pull Knob as far back as you can. Check to make
sure the Firing Pin is hitting the rim of the power load.
•
If the power load sounds like a dud and the dummy only
launches a few feet, make sure the inside of the dummy
tube is clean and dry (especially when launching into wa-
ter). You can also try replacing the o-ring.