14
INSTALLING/REMOVING DUMMY LAUNCHER
WARNING - Do not remove/install Dummy Launcher
while loaded with a Power Load.
1. If you are installing your existing Super-Pro Dummy
Launcher, remove the foam padding from the handle.
2. Remove the 4 screws found under the foam padding.
3. Attach the Dummy Launcher Mounting Bracket using
the 4 exposed screw holes (
fig.1
).
4. Unscrew the hex screws in the Ratcheting Cocking
Lever so that it no longer protrudes out the other side.
5. Slightly pull the Dummy Launcher Pull Knob and slide
the Ratcheting Cocking Lever over it (
fig.2
).
6. Screw in the hex screws to lock the Ratcheting Cock-
ing Lever in place (
fig.3
).
7. Make sure the Self-Contained Firing Pin is securely
tightened into the Dummy Launcher.
8. Detach the spring from the Ratcheting Safety Arm and
swing the arm to the other side (
fig.4
).
9. Pull the Pull Knob completely out and fit the Firing Pin
rod though the groove in the Launcher Base with the
Ratcheting Cocking Lever and the Dummy Launcher
Locking Lever facing up (
fig.5
).
10. Insert Dummy Launcher into Launcher base with the
Locking Lever facing up (
fig.6
).
11. Slide Ratcheting Cocking Lever into its track (
fig.7
).
12. Completely insert Dummy Launcher and secure with
four Dummy Launcher Mounting Screws (
fig.8
).
13. Swing the Ratcheting Safety Arm back in place and
reattach the spring (
fig.9
).
These directions are for adding a Super-Pro Dummy
Launcher unit to a RDL 1202 Launcher Base and for re-
moving the Dummy Launcher for periodic maintenance.
