xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
create iproute ipv6
Purpose
Used to create Ipv6 route entries to the Switch’s IP routing table.
Syntax
create iproute ipv6 <ipv6networkaddr> < ipv6addr > {<metric 1-65535>}
Description
This command is used to create a primary and backup IP route entry to the
Switch’s IP routing table.
Parameters
<ipv6networkaddr>
−
IPV6 address and netmask of the IP interface that is the
destination of the route. Specify the address and mask information using the
format as ipv6address / prefix_length (ipv6address is hexadecimal number,
prefix length is decimal number, for example 1234::5D7F/32).
<ipv6addr>
−
IPv6 address for the next hop router.
<metric 1-65535>
−
Allows the entry of a routing protocol metric entry,
representing the number of routers between the Switch and the IP address
above. The default setting is 1.
Restrictions Only
administrator-level users can issue this command.
Example Usage:
To add a single static IPv6 entry in IPv6 format:
DGS-3400:4# create iproute 1234::5D7F/32 2D30::AC21
Command: create iproute 1234::5D7F/32 2D30::AC21
Success.
DGS-3400:4#
delete iproute ipv6
Purpose
Used to delete an static IPv6 route entry from the Switch’s IP routing
table.
Syntax
delete iproute ipv6 {<ipv6networkaddr> <ipv6addr> | all}
Description
This command will delete an existing static IPv6 entry from the Switch’s
IP routing table.
Parameters
<ipv6networkaddr>
−
IPV6 address and netmask of the IP interface that
is the destination of the route. Specify the address and mask information
using the format as ipv6address / prefix_length (ipv6address is
hexadecimal number, prefix length is decimal number, for example
1234::5D7F/32).
<ipv6addr>
−
IPv6 address for the next hop router.
all
−
This will delete all IPv6 static entries for the destination and next
hop.
Restrictions Only
administrator-level users can issue this command.
Example Usage:
To delete a static IPv6 entry from the routing table:
185
