xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
20
802.1X C
OMMANDS
The DGS-3400 implements the server-side of the IEEE 802.1x Port-based and MAC-based Network Access Control. This
mechanism is intended to allow only authorized users, or other network devices, access to network resources by establishing
criteria for each port on the Switch that a user or network device must meet before allowing that port to forward or receive frames.
The 802.1X commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command Parameters
enable 802.1x
disable 802.1x
show 802.1x auth_state
{ports <portlist>}
show 802.1x auth_configuration {ports
<portlist>}
config 802.1x auth_protocol
[local | radius_eap]
create 802.1x user
<username 15>
delete 802.1x user
<username 15>
show 802.1x user
show auth_statistics
{ports <portlist | all>}
show auth_diagnostics
{ports <portlist | all>}
show auth_session_statistics
{ports <portlist | all>}
show auth_client
show acct_client
config 802.1x capability ports
[<portlist> | all] [authenticator | none]
config 802.1x auth_parameter ports
[<portlist> | all] [default | {direction [both | in] | port_control
[force_unauth | auto | force_auth] | quiet_period <sec 0-
65535> | tx_period <sec 1-65535> | supp_timeout <sec 1-
65535> | server_timeout <sec 1-65535> | max_req <value 1-
10> | reauth_period <sec 1-65535> | enable_reauth [enable |
disable]}]
config 802.1x init
[port_based ports [<portlist> | all] | mac_based [ports]
[<portlist> |all] {mac_address <macaddr>}]
config 802.1x auth_mode
[port_based | mac_based]
{port_based ports [<portlist> | all] | mac_based [ports]
[<portlist> | all] {mac_address <macaddr>}]
config radius add
<server_index 1-3> <server_ip> key <passwd 32> [default |
{auth_port <udp_port_number 1-65535> | acct_port
<udp_port_number 1-65535>}]
config radius delete
<server_index 1-3>
config radius
<server_index 1-3> {ipaddress <server_ip> | key <passwd
32> [auth_port <udp_port_number 1-65535> acct_port
<udp_port_number 1-65535>]}
show radius
config 802.1x reauth
Each command is listed, in detail, in the following sections
136
