D-Link DXS-3600 Series, Cli Reference Manual

Page: 899 / 1456

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
894
Usage Guideline
Use this command without parameters to display the sessions associated with all ports.
Example
This example shows how to display sessions on Ethernet port 1/0/1.
Switch# show authentication sessions interface ethernet 1/0/1
Interface: eth1/0/1
MAC Address: 00-16-76-35-1A-38
Authentication VLAN: 1
Authentication State: Success
Accounting Session ID: 0000000000CB
Authentication Username: wac
Client IP Address: 10.90.90.9
Aging Time: 3590 sec
Method State
WEB-based Access Control: Success, Selected
Total Authenticating Hosts: 0
Total Authenticated Hosts: 1
Total Blocked Hosts: 0
Switch#
Display Parameters
Interface The authentication host received interface.
MAC Address The MAC address of authentication host.
Authentication VLAN The original VLAN of the host start authentication.
Authentication State The authentication status of host.
Start – Host received, but no any authentication start.
Initialization – Authentication resource ready, but no new
authentication start.
Authenticating – Host is under authenticating.
Failure – Authentication failure.
Success – Host pass authentication.
Accounting Session ID The accounting session ID that used to do accounting after
authenticated.
Authentication Username
It indicates the user name of host. It's not available while the host is
selected by MAC-Auth.
Client IP Address It indicates the address of the client associates. It's only available while
the host is selected by Web-Auth or JWAC.
Assigned VID Effectively assigned VLAN ID that was authorized after the host
passed authentication.
Assigned Priority Effectively assigned priority that was authorized after the host passed
authentication.
Assigned Ingress Bandwidth
Effectively assigned ingress that was authorized after the host passed
authentication.
Assigned Egress Bandwidth Effectively assigned egress that was authorized after the host passed