D-Link DXS-3600 Series, Cli Reference Manual, Page: 356 / 1456

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
351
Command Default Level
Level: 12.
Usage Guideline
A binding entry is a mapping between the IP address and the hardware address or the client identifier. By
creating a manual binding entry, an IP address is manually assigned to a client.
Only one manual binding entry can be specified in a DHCP address pool. With a binding entry, the IP
address can be either bound with a client identifier or bound with the hardware address of the host.
Use the client-identifier command and the host command to specify the manual binding entry based on
client identifier in the DHCP packet. Use the hardware-address command and the host command to
specify the manual binding entry based on hardware address.
Example
This example shows how a DHCP address pool “pool1” is created with a manual binding entry which
binds the IP address 10.1.2.100/24 with the MAC address C2:F3:22:0A:12:F4.
Switch# configure terminal
Switch(config)# ip dhcp pool pool1
Switch(config-dhcp-pool)# hardware-address C2F3.220A.12F4
Switch(config-dhcp-pool)# host 10.1.2.100/24
Switch(config-dhcp-pool)#
22-12 host
This command is used to specify the IP address of the manual binding entry in a DHCP address pool.
Use the
no command to remove the specification of the IP address from the entry.
host {IP-ADDRESS MASK | IP-ADDRESS/PREFIX-LENGTH}
no host
Parameters
IP-ADDRESS Specifies the IP address of the manual binding entry.
MASK Specifies the bits that mask the network part of the host address.
PREFIX-LENGTH Specifies the prefix length of the network. It is an alternative way to
specify the network mask.
Default
None.
Command Mode
DHCP Pool Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Only one binding entry can be specified in a DHCP address pool. In a binding entry, the IP address can
be either bound with a client identifier or bound with the hardware address of the host.