DXS-3326GSR Gigabit Layer 3 Switch
upgrade through Telnet.
S - If the IP address has this letter attached to it, it denotes a firmware
upgrade through the Simple Network Management Protocol (SNMP).
•
•
W - If the IP address has this letter attached to it, it denotes a firmware
upgrade through the web-based amangement interface.
User
States the user who downloaded the firmware. This field may read “Anonymous” or
“Unknown” for users that are not identified.
Config Firmware Image
The
Config Firmware Image
window allows users to configure firmware images saved in the memory of the Switch. To
access the following window, click
Maintenance > Multiple Image Services > Config Firmware Image
.
Figure 11- 6. Config Firmware Image window
This window offers the following information:
Parameter
Description
Image
Select the firmware image to be configured using the pull-down menu. The Switch
allows two firmware images to be stored in the Switch’s memory.
Active
This field has two options for configuration.
•
Delete
– Select this option to delete the firmware image specified in the
Image field above.
•
Boot
– Select this option to set the firmware image specified above as the
boot up firmware for the Switch. This firmware will be set as the boot up
firmware after a switch reboot has been performed. The default setting has
firmware image ID 1 as the boot up firmware image for the Switch unless
specified here.
Click
Apply
to implement changes made.
Ping Test
PING is a small program that sends ICMP Echo packets to the IP address you specify. The destination node then responds
to or "echoes" the packets sent from the Switch. This is very useful to verify connectivity between the Switch and other
nodes on the network.
243
