D-Link Systems, Inc.
9
DWS-1008 Install Guide
Getting Started
Connecting to the Network
Use the following procedures to connect a DWS-1008 switch to DWL-8220AP
access points or other 10/100 Ethernet devices.
Connecting to a DWL-8220AP or Other 10/100 Ethernet Devices
Note:
The 10/100 Ethernet ports are confi gured as wired network ports by
default. You must change the port type for locally connected DWL-8220AP
access points, and for wired end stations that use AAA through the DWS-1008
switch to access the network.
For installations in Japan: Provide an earthing connection before you connect
the mains plug to the mains. When disconnecting the earthing connection,
make sure to disconnect only after you pull out the mains plug for the mains.
1. Insert a CAT5 cable with a standard RJ-45 connector. The 10/100 Ethernet
ports on the DWS-1008 switch provide automatic MDI/MDX.
2. If the cable is directly attached to a DWL-8220AP access point:
• For a fi rst-time installation, set the port type to activate the link.
• If the port type is already set for an access point, observe the
appearance of the MP LED for the port.
3. If the cable is attached to a wired end station that uses AAA through the
switch to access the network:
• For a fi rst-time installation, set the port type to activate the link.
• If the port type is already set for a wired authentication port, go on
to step 4.
4. If the cable is directly attached to a device other than an DWL-8220AP
access point:
• Observe the appearance of the Link LED for the port.
• If the Link LED is unlit, check the cable and verify that the device at
the other end of the link is operating.
Getting Started (continued)
Summary of Contents for DWS-1008
Page 1: ......
Page 15: ...D Link Systems Inc 15 DWS 1008 Install Guide Notes Notes ...
