D-Link DWS-1008, Installation Manual

Page: 11 / 16

D-Link Systems, Inc. 11
DWS-1008 Install Guide Confi guration
CLI Quickstart Command
The quickstart command runs a script that interactively helps you confi gure
the following items:
• System name
• Country code (regulatory domain)
• System IP address
• Default route
• Administrative users and passwords
• Unencrypted (clear) SSID names
• Usernames and passwords for guest access using WebAAA
• Encrypted (crypto) SSID names and dynamic WEP encryption for
encrypted SSIDs’ wireless traffi c
• Usernames and passwords for secure access using 802.1X
authentication using PEAP-MSCHAP-V2 and secure wireless data
encryption using dynamic Wired Equivalent Privacy (WEP)
• Directly connected DWL-8220AP access points
• Distributed access points
The quickstart command displays a prompt for each of these items, and lists the
default if applicable. You can advance to the next item, and accept the default
if applicable, by pressing Enter. Depending on your input, the command also
automatically generates the following key pairs and self-signed certifi cates:
• SSH key pair (always generated)
• Admin key pair and self-signed certifi cate (always generated)
• EAP (802.1X) key pair and self-signed certifi cate (generated if you
type usernames and passwords for users of encrypted SSIDs)
• WebAAA key pair and self-signed certifi cate (generated if you type
usernames and passwords for users of unencrypted SSIDs)
The command automatically places all ports that are not used for directly
connected access points into the default VLAN (VLAN 1).
Caution: The quickstart command is for confi guration of a new switch only. After
prompting you for verifi cation, the command erases the switch’s confi guration
before continuing. If you run this command on a switch that already has a
confi guration, the confi guration will be erased. In addition, error messages
such as Critical AP Notice for directly connected APs can appear.
Confi guration (continued)