D-Link DSR-250, Cli Reference Manual

Page: 29 / 83

Unified Services Router CLI Reference Guide
27
8.19 net port management configure
<port_name>
Sl No Command Name Description Type and Description
1 port_name port name LAN/WAN to manage
dedicated port's Port name,
Port1-LAN/Port2-WAN
2 auto_negotiation_enable Select this to let the gateway and
network to determine the optimal port
settings. Boolean Choice (Y/N)
Enable/disable auto negotiation
option,
3 duplex_mode Choose between Half Duplex and Full
Duplex based on the port support. The
default is Full Duplex for all ports. Duplex mode type,
Half or full
4 enable Enable/Disable the port status Boolean choice (Y/N),
Port status enable/disable
5 speed One of three port speeds can be
selected: 10 Mbps, 100 Mbps and 1000
Mbps (i.e. 1 Gbps). The de
fault setting is 1000 Mbps for all ports Port speed type,
10/100/1000
6 cancel Roll back port management
configuration changes
7 exit Save port management configuration
changes and exit current mode
8 save Save port management configuration
changes
8.20 net radvd configure
Sl No Command Name Description Type and Description
1 enable
Enable the RADVD process here to
allow stateless auto configuration of the
IPv6 LAN network Boolean choice (Y/N),
Radvd status
2 life_time
The lifetime in seconds of the route.
The default is 3600 seconds. Integer,
Advertisement Lifetime
3 mode select N to send router advertisements
(RA’s) to all interfaces else Y Boolean Choice (Y/N),
Advertisement mode status
4 mtu
This is used in RA’s to ensure all nodes
on the network use the same MTU
value in the cases where the LAN MTU
is not well known. The default is 1500
Mtu size,
It takes value between 1200 to
1500.
5 preference Chose between low/medium/high for
the preference associated with this
router’s RADVD process Radvd preference type,
Low/medium/high
6 flags managed_enable Chose Managed to use the
administered /stateful protocol for
address auto configuration Boolean choice (Y/N)
Enable or disable the managed flag
7 flags other_enable the Other flag is selected the host uses
administered/stateful protocol of other
(i.e. non-address) information auto
configuration. Boolean choice (Y/N),
Enable or disable other flags