Unified Services Router
CLI Reference Guide
12
Chapter 5. Show commands used in
CLI
The show commands for all the above mentione d branches are outlined in this section.
The command show net ? at the CLI prompt would give the description of all the show
commands in the branch net, which is as follows:
Sl No
Command Name
Purpose
1
show net available_lan_host list
Display available lan host list
2
show net bandwidth profile setup
Display bandwidth profile configuration
3
show net ddns setup
Display ddns configuration
4
show net dhcp leased_clients list
Display dhcp leased clients list
5
show net dhcp reserved_ip setup
Display dhcp reserved ip configuration
6
show net routing dynamic setup
Display dynamic routing configuration
7
show net mode setup
Display network mode configuration
8
show net ipv6_tunnel setup
Display ipv6 tunnel’s configuration
9
show net lan ipv4 setup
Display ipv4 lan configuration
10
show net port management setup
Display port management configuration
11
show net radvd setup
Display radvd configuration
12
show net routing mode setup
Display routing mode configuration
13
show net routing static ipv4 setup
Display ipv4 static routes configuration
14
show net routing static ipv6 setup
Display ipv6 static routes configuration
15
show net statistics
Display network statistics
16
show net bandwidth traffic_selector setup
Display bandwidth traffic selector configurations
17
show net upnp portmap
Display upnp portmap
18
show net upnp setup
Display upnp configuration
19
show net wan wan1 ipv4 setup
Display ipv4 wan1 configuration
20
show net wan wan1 ipv4 status
Display ipv4 wan1 connection status
21
show net wan wan2 ipv4 setup
Display ipv4 wan2 configuration
22
show net ddns setup
Display ddns configuration for dedicated WAN and
configurable WAN
23
show net routing protocol_binding setup
Display protocol binding configuration
24
show net dmz dhcp reserved_ip setup
Display dhcp reserved ip configuration
