Installation Overview
D-Link DSL-2640R User Manual
Power on Router
The Router must be used with the power adapter included with the device.
1. Connect the power adapter to the
Power Input
(12V AC 1.2A) on the back panel of the Wireless ADSL Router and plug the other end of the power adapter to a wall
outlet or power strip.
2. Push
the
Power Button
toggle the power on.
3. The
Power
LED on the front panel will shine bright green to indicate the device is powered on.
4. If the Ethernet port is connected to a working device, check the
LAN
LED indicator to make sure the connection is valid. The Wireless ADSL Router will attempt to
establish the ADSL connection, if the ADSL line is connected and the Wireless ADSL Router is properly configured the
ADSL
LED will light up after several seconds. If
this is the first time installing the device, some settings may need to be changed before the Wireless ADSL Router can establish a connection.
Factory Reset Button
The Router may be reset to the original factory default settings by using a ballpoint or paperclip to gently push down the reset button in the following sequence:
1. With the router powered on (check the Power LED to make sure it lights steady green), press and hold down the reset button using a paper clip or similar object for about
6 to 8 seconds.
2. The router will restart. Watch the Power LED to verify that it is restarting.
3. When it is powered on again it is ready to be configured. The whole process takes about 30 seconds.
4. The device settings will be restored to the factory default IP address
192.168.1.1
and the subnet mask is
255.255.255.0
, the default management Username is “admin”
and the default Password is “admin.”
Note: A factory reset will erase the current configuration settings and reset them to the default settings. After it has restarted, log in to the router’s web-based management
interface and use the Setup Wizard to configure the basic settings.
10
Summary of Contents for DSL-2640R
Page 1: ......
