65
D-Link DSL-226 User Manual
Section 4 - Configuration
ACL
The Access Control List (ACL) page allows you to enable or disable various
services of the router to be used within the LAN or from the WAN side. To
access this page, go to
Features > ACL
. To start enforcing the ACL, click
Activated
.
Access Control Setup
ACL Rule Index:
Select the rule index from the drop-down menu.
Active
Activate or deactivate this particular access rule. Activated means the
particular service can be accessed by the specified IP address range.
Deactivated means the particular service cannot be accessed by the
specified IP address range.
Source IP Address:
Enter the IP address range to apply the rule to. Only addresses in the
specified range have the permission to access this router with the
below application. Enter 0.0.0.0 to allow any IP address to access the
router.
Application:
Select a pre-defined service: Web, Telnet, Ping or All for all of the
above services.
ACL Rule
IndexInterface:
Select the interface from the drop-down menu to apply this access
rule: Both, WAN, or LAN. For Telnet, only LAN is available.
Note:
When setting ACL rules, be sure of the impact on the operation. For instance, if you
modify the default ACL for web access IP range - 0.0.0.0~0.0.0.0 (any IP address) to not Active,
then any device on the LAN cannot access the web configuration.
Click
Set
when you are done or
Delete
to remove the selected rule. A
maximum of 4 rules can be defined.
