D-Link DES-3350SR, Reference Manual

Page: 109 / 486

DES-3350SR Layer 3 Gigabit Switch
105
local>delete link_aggregation group_id 6
Command: delete link_aggregation group_id 6
Success.
local>
config link_aggregation
Purpose Used to configure a previously created link aggregation group.
Syntax config link_aggregation group_id <value 1-6> {master_port
<port> | ports <portlist> | state [enable | disable]
Description This command allows you to configure a link aggregation group that
was created with the
create link_aggregation command above.
The DES-3350SR supports link aggregation cross box which
specifies that link aggregation groups may be spread over multiple
switches in the switching stack.
Parameters group _id <value 1-6>
−
Specifies the group ID. The switch allows up
to 6 link aggregation groups to be configured. The group number
identifies each of the groups.
master_port<port>
−
Master port ID. Specifies which port (by port
number) of the link aggregation group will be the master port. All of
the ports in a link aggregation group will share the port configuration
with the master port.
ports <portlist>
−
Specifies a range of ports that will belong to the link
aggregation group.
state [enable | disable]
−
Allows you to enable or disable the
specified link aggregation group.
Restrictions Only administrator-level users can issue this command. Link
aggregation groups may not overlap.
Example usage:
To define a load-sharing group of ports, group-id 1,master port 5 of module 1 with group members ports 5-7 plus port 9:
local>config link_aggregation group_id 1 master_port 1:5 ports 1:5-1:7,
1:9
Command: config link_aggregation group_id 1 master_port 1:5 ports 1:5-
1:7, 1:9
Success.
local>