D-Link DES-3010PA - Switch, Web User Manual

Page: 42 / 294

Starting and Configuring the Device
Startup Procedures
Page 41
Startup Procedures
This section includes the following topics:
•
Startup Menu Procedures
•
Software Download and Reboot
Startup Menu Procedures
The procedures called from the Startup menu cover software download, flash handling, and password recovery.
The diagnostics procedures are for use by technical support personnel
only and are not disclosed in this
document.
The Startup menu can be entered when booting the device. A user input must be entered immediately after the
POST test.
To enter the Startup menu:
1. Turn the power on and watch for the auto-boot message.
This command will reset the whole system and disconnect your current
session. Do you want to continue (y/n) [n] ?
y
**************************************************
***************** SYSTEM RESET *****************
**************************************************
------ Performing the Power-On Self Test (POST) ------
UART Channel Loopback Test........................PASS
Testing the System SDRAM..........................PASS
Boot1 Checksum Test...............................PASS
Boot2 Checksum Test...............................PASS
Flash Image Validation Test.......................PASS
BOOT Software Version 1.0.0.03 Built 09-Mar-2006 19:33:13
DLink 3010 Switch based on 88E6218 with ARM946E-S.
32MByte SDRAM. I-Cache 8 KB. D-Cache 8 KB. Cache Enabled.
Autoboot in 2 seconds - press RETURN or Esc. to abort and enter prom.
2. When the auto-boot message appears, press <Enter> to display the Startup menu. The Startup menu
procedures can be done using the ASCII terminal or Windows HyperTerminal.
[1] Download Software
[2] Erase Flash File
[3] Erase Flash Sectors
[4] Password Recovery Procedure
[5] Enter Diagnostic Mode
[6] Back
Enter your choice or press 'ESC' to exit:Enter your choice or press 'ESC' to exit:
The following sections describe the available Startup menu options.