18
D-Link DBA-1210P User Manual
Section 3 - Configuration
You can view various information by using the following CLI commands, including network status, Cloud connection status,
and device information. All of the parameters need the command
apply
to take effect.
Action
Commands
Get Current Settings for the Ethernet (Wired) Internal Interface.
get management
View the connection type.
get management dhcp-status
Use DHCP as the connection type.
set management dhcp
Use a Static IP as the connection type, and then static IP address, subnet mask
and default gateway.
set management static
static-ip
ip_address
mask
netmask
gateway
ip_address
View the DNS name server mode.
get host dns-via-dhcp
Set DNS Name servers to use static IP addresses.
set host static-dns-1
ip_address
or
set host static-dns-1
ip_address
static-dns-2
ip_address
Set DNS name servers to use DHCP IP addressing (Manual to Dynamic Mode).
set host dns-via-dhcp {up | down}
View VLAN information.
get management vlan-id
get management vlan-enable
get management vlan-mode
Enable/Disable the VLAN tagging.
set management vlan-enable {up | down}
Set the VLAN ID.
set management vlan-id
value
Enable/Disable the VLAN mode.
set management vlan-mode {tagged | untagged}
View IPv6 information.
get management ipv6-enable
Enable/Disable IPv6 function.
set management ipv6-enable {up | down}
Upgrade the device firmware.
firmware-upgrade
url
View Proxy information.
get management proxy-enable
get management proxy-host
get management proxy-port
Enable/Disable Proxy server.
set management proxy-enable {up | down}
Set IP address or domain name of proxy server.
set management proxy-host
ip_address
set management proxy-host
domain_name
Set port number of proxy server.
set management proxy-port
port
Apply the configuration.
apply
Exit command line.
exit
Reboot the system.
reboot
Access Point Local Settings
