English
English
99.831.06 1.4/04/23
99.831.06 1.4/04/23
VCD 204
VCD 204
6/16
7/16
Closing edge protection
In the "CLOSE" direction the drive has an active
protection for the main closing edge. If there is an
overload in the closing ranges 3 and 2, the drive runs
"OPEN" for 20 seconds, then "CLOSE" again. If
closing is not possible after three attempts, the drive
remains in this position.
In addition, the drive is equipped with passive
protection. The closing speed in closing range 2 and
1 is reduced to 5 mm/s.
Significantly greater forces can be
exerted at the secondary closing edges.
Danger of crushing hands and fingers!
Main closing edge
Beside closing edge
Beside -
closing edge
Stroke limiting with magnets
Voltage must continue to
be applied to the drive when
moving in the “CLOSE”
direction.
Hold the magnet next to
the drive as shown in the
diagramme (2 sec.) until you hear a
pulsating ton >
The
drive
is
now
in
learning
mode
.
The
magnet
can
now
be
removed
and
the
drive
no
longer
has
to
be
under
voltage
.
Close drive.
1
Allow the drive to run
“OPEN” until you reach the
required stroke.
If the stroke is set incorrectly,
the procedure is accidentally
interrupted or the drive
continues to the full stroke
length, please return to point 1
and start again.
STOP
3
appr
.100 mm
learning mode
appr. 2 sec.
2
When using two VCD 204s on one window, both drives must be electrically connected in order to
set the stroke, although only one drive needs to be switched to the stroke learning mode with the
magnet.
All approx. 20 % switch-off reserve (temporary)
Closure Ranges
~6 mm/s
200 N
(Safety cut-off force)
5 mm/s
150 N
77 mm
~6 mm/s
200 N
23 mm
Mount the drives mechanical stress-free.
With that, a better load distribution is ensured on all
the drives.
Mounting informations
Running speed and forces
Type
VCD 204
Power supply
24 V DC / ± 20 %
Nominal current
0,35 A
Nominal force
200 N
Nominal locking force
approx. 2000 N (Excluding bracket)
Service life
>20 000 double strokes
Duty cycle
30 % (With cycle time 10 minutes)
Housing
Zinc-diecasting, powdercoated
Ingress protection
IP 30
Temp. range
0 ... +60 °C
Emission sound pressure level
LpA ≤ 46 dB(A)
/
Nominal stroke length * **
See type plate
Additional functions **
Closing edge protection activated (3 stroke repeatings);
Locking relief activated
*Adjustable with PLP 1
** Programmable with PLP 1 and SCS
Technical data
Electrical devices, accessories, batteries and packa-
ging should be sorted for environmental-friendly
recycling. Do not dispose electrical devices and
batteries into household waste!
Only for EC countries:
According the European Guideline 2012/19/EU for
waste electrical and electronic equipment and its
implementation into national right, electrcal devices
that are no longer usable must be collected separa-
tely and disposed of in an environmentally correct
manner.
Disposal
