D.A.C.E CONDO, Manual

Page: 4 / 21

4
TERMS AND DEFINITIONS
·
Auto­close : allows the gate to close automatically after a selected time period.
·
Multi­user mode : this is a setting used in town house situations where there are multiple triggers. This
setting will avoid the motor getting multiple triggers at the same time.
·
Pedestrian access : allows only partial opening of the gate
·
Anti­lift device : stops the gate being lifted off the rail.
·
Battery : the battery is used to drive the motor.
·
Safety Beams : These reduce the risk of the gate closing on a vehicle. Beams should always be used
when auto­close is selected.
·
Transformer : the transformer reduces the mains power to 16 VAC. NOTE! The cable to be used from
the transformer to the main PC board must be a minimum of 1.5mm cable. DO NOT use
communications cable.
·
Charger module : the on­board charger receives 16 VAC from the transformer and then delivers a
trickle charge to maintain ± 13.8 VDC charge to the battery.
·
Main PC board : this is the printed circuit board that contains all the electronic components that oper­
ate the motor. NOTE! Always remove the power from the PC board before connecting any out­put
wires.
·
Remote/Transmitter : this is usually a hand held product which transmits a radio signal to the
r
e
ceiver.
·
Receiver : the receiver triggers the motor after receiving a radio signal from the transmitter.
·
Test button : this is a button on the main PC board that can be used to activate the motor. This is
usually used during the programming of the motor.
·
Rack : this is a length of toothed gear mounted on the gate.
·
Pinion gear : this is the gear that meshes with the rack in order to drive the gate. NOTE! This is a
serviceable part.
·
Foundation plate : this is the steel plate that is mounted to a concrete plinth in the ground. The motor is
mounted onto the foundation plate using the three mounting bolts.
·
Thumb wheel : this allows the motor to be put into Manual Override mode so that the gate can be
operated manually by hand.