2
The Suprex Ethernet SPX-7200 series makes it possible to install card readers far from the access control panel, by
providing a network link between the door or gate readers, and most manufacturers’ panels. The Suprex includes both a
Remote (door/gate) unit and a Central (Controller) unit. The SPX-7200 series devices are compatible with the EXP-2000
expansion modules to allow for up to 8 readers to operate on a single network connection.
Cypress Suprex® Ethernet Series - SPX-7200 Overview
Specifications
Part Numbers
SPX-7200
816684003066
Ethernet Reader-Extender (paired Central and Remote units)
SPX-7200C
816684005503
Ethernet Reader-Extender (Central unit only)
SPX-7200R
816684001673
Ethernet Reader-Extender (Remote unit only)
EXP-2000
816684003233
Optional Expansion Module Set to connect additional reader
Physical
SPX-7200 Enclosure
4.50” x 3.07” x 2.02” / 0.445 lbs (diagram below)
EXP-2000 Enclosure
4.50” x 2.83” x 0.94” / 0.3 lbs (diagram below)
Environmental
Storage Temperature
-40˚C to 100˚C
Operating Temperature
-30˚C to 60˚C
Electrical
Central and Remote Supply Voltage
8-16Vdc Current 300mA
Relays
Max Switching
220Vdc 30W (resistive) 1A / 250Vac 37.5VA 1A
Running Spec with load
30Vdc 1A (resistive) / 125 Vac 0.3A (resistive), 1x10
5
operations @ 20˚C
Data I/O
Interface
Wiegand (maximum 248 bits - pass through),
Strobed (Clock & Data), F/2F (Unsupervised)
LED 0-30V
Network
Specifications
Network Interface
RJ45 Ethernet 10Base-T or 100Base-TX (auto-sensing)
Compatibility
Ethernet: Version 2.0/IEEE 802.3 (electrical), Ethernet II frame type
Protocols Supported
TCP/IP, ARP, UDP/IP, ICMP, DHCP, BOOTP, TFTP, Auto IP, HTTP, SMTP
Note: For standard use cases, the SPX-7200 uses TCP/IP
Range
Network
As extensive as the network (maximum of 328 feet between Central or Remote and switch/hub/router)
Crossover
Cable
328 feet between Central and Remote
Additional
Features
SPX-7200 includes complete solution with Central (controller) and Remote (reader/gate/door) interface
“Quiet” bandwidth and power
Field-configurable network settings
On-board relays to control door/gate
Auxiliary I/O available for LED signal and door/gate/panel status signal
Status LED and Supervision Relay (default off) monitor network connection status
