Document Number: 002-04721 Rev.*A
Page 68 of 74
MB966B0 Series
Page
Section
Change Results
Changed the Description of Vector number 64
Reload Timer 6 can be used as PPG clock source
→
Reload Timer 6
28
Added Vector name to Vector number 95
SG0
29
Added Vector name to Vector number 121
SG1
30 to 33
Handling Precautions
Added a section
35
Handling Devices
Added the description to
“3. External clock usage”
(3) Opposite phase external clock
Changed the description in “7. Turn on sequence of power
supply to A/D
converter and analog inputs”
In this case, the voltage must not exceed AVRH or AV
CC
(turning the analog and digital power supplies simultaneously
on or off is acceptable).
→
In this case, AVRH must not exceed AV
CC
. Input voltage for
ports shared with analog input ports also must not exceed
AV
CC
(turning the analog and digital power supplies
simultaneously on or off is acceptable).
36
Added the description “12. Mode Pin (MD)”
37
Electrical Characteristics
1. Absolute Maximum Ratings
Added Symbols of High current port
Changed the annotation *3
Input/Output voltages of standard ports depend on V
CC
.
→
Input/Output voltages of general I/O ports depend on V
CC
.
38
Changed the annotation *4
Note that if the +B input is applied during power-on, the power
supply is provided from the pins and the resulting supply
voltage may not be sufficient to operate the Power reset
(except devices with persistent low voltage reset in internal
vector mode).
→
Note that if the +B input is applied during power-on, the power
supply is provided from the pins and the resulting supply
voltage may not be sufficient to operate the Power reset.
Added the annotation *4
The DEBUG I/F pin has only a protective diode against V
SS
.
Hence it is only permitted to input a negative clamping current
(4mA). For protection against positive input voltages, use an
external clamping diode which limits the input voltage to
maximum 6.0V.
39
2. Recommended Operating Conditions
Added the Value and Remarks to “Power supply voltage”
Min: 2.0V
Typ: -
Max: 5.5V
Remarks: Maintains RAM data in stop mode
Changed the Value
of “Smoothing capacitor at C pin”
Typ: 1.0
F
→ 1.0
F to 3.9
F
Max: 1.5
F
→ 4.7
F
Changed the Remarks
of “Smoothing capacitor at C pin”
Deleted “(Target value)”
Added
“3.9
F
(Allowance within ± 20%)”
40
3. DC Characteristics
(1) Current Rating
Deleted “(Target value)” from Remarks
Added the Symbol to
“Power supply current in Run modes”
I
CCRCH
, I
CCRCL
