Cypress MB966B0 Series, Manual

Page: 6 / 74

Document Number: 002-04721 Rev.*A Page 6 of 74
MB966B0 Series
1. Product Lineup
Features MB966B0 Remark
Product Type Flash Memory Product
Subclock Subclock can be set by software
Dual Operation Flash Memory RAM -
128.5KB + 32KB 8KB MB96F6B5R, MB96F6B5A
Product Options
R: MCU with CAN
A: MCU without CAN
256.5KB + 32KB 16KB MB96F6B6R
Package
LQFP-100
FPT-100P-M20
DMA 4ch
USART 5ch LIN-USART 0 to 2/4/5
with automatic LIN-Header
transmission/reception
2ch LIN-USART 0/1
with 16 byte RX- and
TX-FIFO
I
2
C 1ch I
2
C 0
8/10-bit A/D Converter 27ch
AN 2 to 4/6 to 8/10 to 12/
14 to 31
with Data Buffer No
with Range Comparator Yes
with Scan Disable Yes
with ADC Pulse Detection Yes
16-bit Reload Timer (RLT) 5ch RLT 0 to 3/6
16-bit Free-Running Timer (FRT) 2ch FRT 0/1
16-bit Input Capture Unit (ICU)
6ch
(5 channels for LIN-USART)
ICU 0/1/4 to 7
(ICU 0/1/4 to 6
for LIN-USART)
16-bit Output Compare Unit (OCU) 4ch OCU 0 to 3
8/16-bit Programmable Pulse Generator (PPG) 12ch (16-bit) / 16ch (8-bit) PPG 0 to 7/12 to 15
with Timing point capture Yes
with Start delay Yes
with Ramp No
Quadrature Position/Revolution Counter
(QPRC)
2ch QPRC 0/1
CAN Interface 1ch
CAN 0
32 Message Buffers
External Interrupts (INT) 16ch INT 0 to 15
Non-Maskable Interrupt (NMI) 1ch
Sound Generator (SG) 2ch SG 0/1
LCD Controller 4COM × 36SEG
COM 0 to 3
SEG 0 to 4/7/11 to 28/30/
33/36 to 45
Real Time Clock (RTC) 1ch
I/O Ports
77 (Dual clock mode)
79 (Single clock mode)
Clock Calibration Unit (CAL) 1ch
Clock Output Function 2ch
Low Voltage Detection Function Yes
Low voltage detection function
can be disabled by software
Hardware Watchdog Timer Yes
On-chip RC-oscillator Yes
On-chip Debugger Yes
Note:
All signals of the peripheral function in each product cannot be allocated by limiting the pins of package.
It is necessary to use the port relocate function of the general I/O port according to your function use.