Kit Operation
CY3677 Evaluation Kit User Guide, Doc. No. 002-12185 Rev. *D
18
8. To program the CY29430 device, select
Program
in the left navigation pane, as shown in
Figure 3-8
. Choose the
appropriate device in the
Select Device (I2C Master)
drop-down list prior to programming, and then click the
Functional
Program
button. This will program the device directly from ClockWizard. LED1 blinks to indicate that the device is being
programmed. The required output will appear on the oscilloscope.
For more information, refer to the ClockWizard 2.1 User Guide located in
Help
>
User guide
of the ClockWizard 2.1
software.
Figure 3-8. Programming Configuration Profile using ClockWizard 2.1
9. The CY29430 supports the selections of four frequency profiles for a single configuration. The Frequency Select inputs
of the CY29430 device (FS0 and FS1) can either be controlled by ClockWizard 2.1 or they can be hard-coded using
jumpers on the board. To allow selection of a frequency profile in ClockWizard 2.1, jumpers J14 and J15 must be set to
positions 2 and 3. With the jumpers in those positions, you can select any of the four available profiles in ClockWizard
2.1 and click
Apply
(see
Figure 3-9
). Refer to the
section
Frequency Select (FS)
for details on the hardware settings.
Figure 3-9. Frequency Select (FS) Operation of the CY29430 device through ClockWizard 2.1