CY3655 Hardware User Guide
Programming enCoRe II or Wireless enCoRe II on the Modular Programmer
enCoRe II devices and Wireless enCoRe II devices can be programmed on the Modular
Programmer using the ICE-Cube. Follow the programming steps below:
1. Using a USB cable, plug the ICE-Cube into a PC that has the PSoC Programmer
application installed. Make sure the ICE-Cube is powered on.
2. Connect the yellow ISSP cable to the ICE-Cube through the RJ45 adapter.
Note
: Do
not use a black ISSP cable as it does not properly support enCoRe II or Wireless
enCoRe II.
3. Place the 5-pin end of the ISSP cable on the 5-pin header (J2) of the Modular
Programmer Base. It will only go on in one orientation.
4. Place enCoRe II or Wireless enCoRe II device in the socket on the Modular
Programmer Base. Any PDIP package is supported natively. Surface mount devices
will require a surface-mount to PDIP adapter (sold separately). See the Programming
Support Matrix table in the next section for recommended surface-mount to PDIP
adapters.
5. Make sure the appropriate module supporting your specific enCoRe II or Wireless
enCoRe II device is in the memory-style DIMM slot of the Modular Programmer Base.
See the table below to find which module and which orientation of the module supports
your device. Note that the correct side of the module (A or B) must be connected to the
DIMM connector, and the module must be snapped properly in place.
6. Launch the PSoC Programmer application.
7. In the programming application, select the Port as the ICE-Cube by choosing
“USB/xxxxCxxx” where the “x” is specific to the USB device ID of your ICE-Cube. Most
likely, the ICE-Cube will be the only device in the list that is not an LPT port.
8. First select the appropriate device family then select the device to be programmed.
9. Load the programming file using the “File Load” button.
10. Program.
Alternatively, a MiniProg programmer (sold separately) can be used for programming rather
than the ICE-Cube. Follow the programming steps below:
1. Using a USB cable, plug the MiniProg programmer into a PC that has the PSoC
Programmer application installed.
2. Place the MiniProg programmer on the 5-pin header (J2) of the Modular Programmer
Base. It will only attach in one orientation.
3. Place enCoRe II or Wireless enCoRe II device in the socket on the Modular
Programmer Base. Any PDIP package is supported natively. Surface mount devices
will require a surface-mount to PDIP adapter (sold separately). See the Programming
Support Matrix table in the next section for recommended surface-mount to PDIP
adapters.
Page 11 of 16