CY8CKIT-026 CAN and LIN Shield Kit Guide, Doc. No. 002-03798 Rev. *C
46
Example Projects
5.4.3
Verify Output
To verify the LIN_Slave_CY8CKIT-042 code example, perform these steps.
Silicon Engines LIN/USB Data Converter
is used as LIN analyzer in this example.
1. Program the CY8CKIT-042 PSoC 4 Pioneer Kit with LIN_Slave_CY8CKIT-042 example project
through USB connector J10.
2. Ensure that the power supply and jumper settings are as explained in
3. Install the 'SE9004 and 9011 LINUSB Message Center software (provided by Silicon Engines) on
your PC and connect the LIN analyzer to PC through USB cable. If a different analyzer is being
used, install the appropriate software.
4. Open the LIN analyzer software and go to
Configure LIN/USB
. Configure LIN Box Interface
window is displayed. Set the
LIN Bus Baud Rate
to 19200 bps, and then select the
LIN 2.0-2.1
Protocol
checkbox, as shown in
Figure 5-7. LIN Analyzer Configurations
5. If you are using any other analyzer, make sure that the checksum setting is selected as
enhanced checksum since LIN v2.1/2.2 specification supports only enhanced checksum (this
option is not required in Silicon Engines LIN-USB converter software).
