11
■ Trigger Wait:
Set the length of time, in seconds, to wait after this
CEC Automation Event has been activated before ANY other
Trigger Event can be detected.
■ Trigger Command:
Set the CEC command to send when
the specified Trigger Event is activated. Clicking the “Test”
button will send the command immediately. Available CEC
commands are:
– Power Off:
Turn off the connected HDMI device.
– Power On:
Turn on the connected HDMI device.
– Active Source:
Force the connected HDMI device to switch
to the HDMI input that this unit is connected to.
Note: Not all HDMI devices support all CEC commands.
■ RS-232:
Enable or disable sending an RS-232 command when
the currently selected Trigger Event is activated.
Note: The RS-232 port must be in “Control” mode to send
commands to external devices.
■ Trigger Delay:
Set the length of time, in seconds, that the
specified Trigger Event must continue to be true before sending
the defined RS-232 command.
■ Trigger Wait:
Set the length of time, in seconds, to wait after this
RS-232 Automation Event has been activated before ANY other
Trigger Event can be detected.
■ Trigger Command:
Click the Edit icon (
) to define the RS-
232 command to send when the specified Trigger Event is
activated. Clicking the “Test” button will send the command
immediately.
2) RS-232 Setting:
Provides controls to configure the settings and
behavior of the RS-232 port.
■ Mode:
Switch the behavior of the RS-232 port between
“Console” and “Control”. When “Console” is selected, the unit
can receive and be controlled directly via RS-232 commands.
When “Control” is selected the RS-232 port can send
Automation commands to control other devices.
■ RS-232 Setting Edit:
Click on the Edit icon (
) to configure the
various RS-232 port settings including baud rate, data length,
parity and stop bits.
Summary of Contents for CH-2537TXWPUS
Page 2: ......
Page 42: ......
Page 43: ......
Page 44: ...CYPRESS TECHNOLOGY CO LTD www cypress com tw ...
