DRAFT
3
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Front Panel
POWER
MUTE
+
-
IN
OPT.
1
1
2
2
3
3
4
SYNC
MUTE
IR
4
TRIG IN
OPTICAL
IN
HDMI
IN
1
2
3 4
7
6
5
6
2
3
4
8
1
POWER Button and LED:
Press this button to switch On or set the
device to standby mode. The LED will illuminate in green when the
device is power On and if it is switched to standby mode the LED
will turn red.
Note:
For IP reset from Static to DHCP mode, press and hold the
power button for 3 seconds while the device is ON and the LED will
blink once.
2
IR Window and LED:
This IR Receiver receives the remote control
signal from the package included remote control only and the LED
will blink when IR signal is receiving.
3
OPTICAL IN Button and LED:
Press this button to select output audio
from optical source and the LED will illuminate.
4
HDMI IN Button and LEDs 1~4:
Press this button to select an input
from the input sources 1~4 and the LED will illuminate according to
the selection.
Note:
For firmware update, press and hold this button then plug-
in the AC power into the device and then the USB flash driver with
updated firmware(s) inside.
5
+/-:
Press these buttons to adjust up/down the output audio sound.
Summary of Contents for CDPS-UH4H1HFS
Page 2: ...D R A F T ...
Page 30: ...D R A F T ...
Page 31: ...D R A F T ...
Page 32: ...D R A F T Home page http www cypress com tw CYPRESS TECHNOLOGY CO LTD ...