CYP AVIP-P5104T-B1C, Operation Manual

Page: 18 / 36

13
DEVICE SETTING
2ND LEVEL
3RD LEVEL
USB Control Mode Host
DEVICE
USB Virtual Hub
(USB Device Mode only)
OFF
On
HDMI Out Source INPUT 1 (HDMI)
Input 2 (DP)
VoIP Out Source
INPUT 1 (HDMI)
Input 2 (DP)
HDMI Out Auto Mode Off
AUTO SWITCH
VoIP Out Auto Mode Off
AUTO SWITCH
1) USB Control Mode: Enable or disable the USB 2.0 (Mini-B) port for
connection to USB host devices such as a PC or laptop. Selecting
“Device” enables the USB 2.0 (Mini-B) port. Selecting “Host” disables the
USB 2.0 (Mini-B) port.
Note: In a Point-to-Point extension configuration, only one of the two
units should be set to “Device” to avoid conflicts.
2) USB Virtual Hub: Enables or disables the “simultaneous connection”
USB mode which allows the PC/Laptop connected to this unit to be
paired with the USB devices on up to 7 “Host” mode units.
Note: Only available when USB Control Mode is set to “Device”. USB
routing can only be configured by use of the optional IP Master Controller
or control software and is not valid in Point-to-Point configurations.
3) HDMI Out Source: Select the input source to display on the HDMI
output.
4) VOIP Out Source: Select the input source to transmit as an AV over IP
stream.
5) HDMI Out Auto Mode: Enable or disable the HDMI output’s automatic
source selection mode. When enabled, the unit will automatically switch
the input routed to the local HDMI output whenever a new source is
detected or if the current source is lost.