Cynko
Met
T-104/6
71
Repeat for each wheel individually, remembering that the lift
must be on the opposite side of the wedges
If the wheel shows excessive backlash, a regulation should be
carried out:
remove the hub cap by prying it out with a screwdriver in
several places around the circumference and remove the cotter
pin of the castellated nut.
Turning the wheel, simultaneously tighten the castellated nut
until the wheel stops completely.
Unscrew the nut by 1/6 -1/3 turn, until covering the next groove
on the pin with a hole in the pivot. The wheel should turn
without excessive resistance, the nut cannot be tightened too
much. It is not recommended to use too strong pressure due to
the deterioration of the working conditions of bearings.
Secure the nut with a new cotter pin, and firmly press the hub
cap.
The mentioned steps should be repeated checking the
remaining wheels.
The wheel, after correct adjustment of the bearings should turn
smoothly without stops and perceptible resistance.
The soundness of bearings backlash has to be finally checked
after driving a few kilometers with the trailer controlling the degree of
the hubs heat by hand.
The cause of the occurrence of significant resistance when
turning the wheel, and strong heating of the hubs apart from
improper adjustment of the bearings backlash can be contaminants
in the lubricant or bearing damage. The above symptoms require
dismantling the wheel hub and removing the fault (replacement of
grease or bearings).
Summary of Contents for T-104
