CynkoMet T-104, Instructions For Use And Operation

Page: 76 / 128

Cynko Met
T-104/6
76
be of the same type. The use of different types of oil is not
permitted.
The hydraulic system of the trailer should be absolutely
tight. Checking tightness of the hydraulic system consists of
connecting the trailer to the tractor, running the hydraulic cylinder
and storing it in the position of the maximum extension of the
cylinder with the loading crate tilted for 30 seconds.
In the case of noticing oil leaks on connections of hydraulic
conduits, you must tighten the connector, if this does not rectify
the fault, replace the conduit or the connector with a new one. If
the oil leak occurs beyond the connection, the leaking conduit
system should be replaced. Exchange of a component to a new
one is also required for any damage of mechanical nature.
Hydraulic hoses should be replaced at least every four to six
years from their date of manufacture, unless previously found to
be damaged and replaced.
In the case of noting oiling on the body of the hydraulic
cylinder, check the nature of the leak. When fully taking out the
cylinder actuator, check all sealing places. Minor leaks with
symptoms of "sweating" are acceptable, but if you see a leak of a
"drip" type, you must stop the operation and repair the failure.
CAUTION!
CAUTION!
Operation of the trailer with a leaking tilting
hydraulic system is unacceptable Using a trailer with a
leaking tilting hydraulic system is unacceptable .
6.5 Handling the spring leaf system.
Operation of the spring leaf is based on controlling the
current state of spring leaves. It should not be allowed to
accumulate a thick layer of dried mud on the springs.