21
Copyright August 2013 Cyclotricity Ltd
Caution: The pads and rotor must be kept clean and free from oil or
grease based contamination.
1-
Holding the pad end-tab, insert it into caliper slot with its
metal backing towards the piston. Make sure the hole in
the metal backing goes over the piston pins. When
correctly inserted, the pad will be held in place
magnetically, repeat the procedure for the other pad.
2-
Pads can be removed by grasping the pad end-tab, lifting
the pad clear of the piston pin and then manoeuvring it
out of the rotor slot in the caliper body.
Note: Disc brake pads are held in the caliper magnetically. No
tools are required to install or remove them. As the left and
right pads are the same they may be inserted on either the left
or right of the caliper.
WARNING: If you are unsure about any part of the installation
process you should seek advice from a professional bike service
centre. Damage due to wrong adjustments will NOT be covered
by your warranty.