6
Version 1.0
Yellow/green
Earth(Ground)
Operation
The LEDE 100B can operate in three different modes� In each mode you can run the fixture as a stand
alone fixture or in a master/slave confiugration� This next section will detail the dif-ferences in the
operating modes�
Addressing
All fixtures should be given a DMX starting address when using a DMX signal, so that the correct fixture
responds to the correct control signals� This digital starting address is the channel number from which
the fixture starts to listen to the digital control information sent out from the DMX controller� The
allocation of this starting address is achieved by setting the correct number on the display located on
the base of the device�
You can set the same starting address for all fixtures or a group of fixtures, or make different address
for
each fixture individually�
If you set the same address, all the units will start to listen to the same control signal from the same
channel number� In other words, changing the settings of one channel will affect all the fixtures
simultaneously�
If you set a different address, each unit will start to listen to the channel number you have set, based on
the quantity of control channels of the unit� That means changing the settings of one channel will affect
only the selected fixture�
In the case of the LEDE 100B, which is 16 channels fixture� If you set, for example, the address in the
16 channel mode to channel 17, the device will use the channel 17 to 32 for control�
Universal DMX Control
This function allows you to use a universal DMX-512 controller to control the chases and patterns,
dimmer and strobe� A DMX controller allows you to create unique programs tailored to your individual
needs�
Auto run mode
In this mode, you can run internal program without a controller�
1� Press the MENU button until “
MODE
” is displayed, and press ENTER�
2� Press the UP or DOWN button so that “
Auto run
” is displayed�
3� The unit will now run auto mode without a DMX controller�
Sound Mode
This mode allows either single unit or several units linked together, to run to the beat of the music�
1� Press the MENU button until “
MODE
” is displayed, and press ENTER�
2� Press the UP or DOWN button so that “
Sound ctrl
” is displayed�
3� The unit will now run to the beat of the music�
Master-Slave Operation
This function will allow you to link up to 16 units together and operate without a controller� In a Master-
Slave set up one unit will act as the controlling unit and the others will react to the controlling units
programs� Any unit can act as a Master or as a Slave�
1� Using approved DMX data cables, daisy chain your units together via the XLR connector on the rear
