EDGE
Page 16
CVHC-01-01/02/03 Revision L Instruction Manual Revision-5 (13-01-2019)
HELMET START SEQUENCE RECAP
1.
Press
ON/OFF
button for 1 seconds to turn cameras
ON.
2.
Front & Rear RED LED camera status lights will display as a solid RED light for (x4) seconds.
3.
Front & Rear RED LED camera status light will go off/out for 3 seconds.
4.
Front & Rear RED LED camera status light will come back on and display as a solid RED light for 3 seconds.
5.
Front & Rear RED LED camera status light starts to flash.
Total start sequence = 10 seconds (approximately).
Pairing the helmet to Wi-Fi is not necessary to continue helmet recording functions, the vision and sound data from
both front and rear cameras is stored within the helmet on twin Micro SD Cards (Flash Drive Cards) and not in the
App.
Flashing
Red
front and rear camera status LED indicators show to the user that the helmet is recording
simultaneously however there is no smartphone Wi-Fi pairing active (at present).
BATTERY CHARGE INDICATOR
At the same time as the
ON/OFF
button is pressed and the RED front and rear LED camera status lights are
illuminated, all four (4) Blue LED battery level indicator LEDs (page 6 - item 18) will illuminate for approximately four
(4) seconds, then revert back to display the remaining useable battery charge.
When fully charged the 3200-mA battery will run the helmet continually for approximately three (2.5) hours
Four
(4) LED lights = 4/4 full charge
Three
(3) LED lights = 3/4 charge
Two
(2) LED lights = 1/2 charge
0ne
(1) LED light = 1/4 charge
For example
1.
Press
ON/OFF
button for 1 second to turn cameras
ON.
2.
Row of 4 LED battery level indicator lights will display as a solid blue LED for 4 seconds.
3.
Example: - If battery is ½ charged the row of 4 LED lights will revert back to display x2 LED solid blue lights
