Joule 3.0 User Guide page 54
Chapter 6: Sensors
Setting Up Resistance Unit Sensors
Joule 3.0 is compatible with CycleOps electronic resistance units (RU) found on the CycleOps
400 Pro indoor cycle and PowerBeam Pro trainer. In order to be paired, CycleOps electronic
resistance units need to be set for pairing by unplugging them for 5 seconds and the plugging
them back in.
1. Press and release [MODE] until
Menu
mode is displayed.
2. Press [JOYSTICK] in and release to select
Sensors.
3. Press [JOYSTICK] up/down to highlight
RU Sensor.
Press [JOYSTICK] in and release to select
RU Sensor
.
4. Press [JOYSTICK] up/down to highlight
Add New Sensor
. Press [JOYSTICK] n and release to select
Add New
Sensor.
5. Make sure the RU sensor has been unplugged and plugged back in in the last 30 seconds.
6. Press the [JOYSTICK] in and release to
Start Pairing
. Pairing may take up to 60 seconds. Once pairing is suc-
cessful, the sensor ID will be displayed.
7. Press [JOYSTICK] up/down to highlight
Name
. Press [JOYSTICK] in and release to select name and change
the name of the paired RU sensor. Press [JOYSTICK] in and release to save changes.
8. Press [JOYSTICK] up/down to highlight
Activate Sensor
. Press [JOYSTICK] in and release to
Activate Sensor
.
Note: active sensor is designated by a hash mark next to the sensor name in the sensor list. When switching RU
sensors, be sure to activate the appropriate sensor.
9. Once a sensor has been paired and activated Joule 3.0 will automatically find the active sensor whenever it is
turned on. Other resistance unit sensors with different IDs will be ignored. Once the sensor is paired, it can be
operated within the same area as other sensors without risk of picking up that signal.
