Cyclades alterpath pm10, Installation, Administration And User Manual, Page: 58 / 140

Default Configuration Parameters
38 AlterPath PM Installation, Administration, and User’s Guide
Default Configuration Parameters
The AlterPath PM’s default configuration is as follows:
• User is admin .
• admin user’s password is pm8 .
• All outlets are un-named .
• All outlets are unassigned to user.
• All outlets are turned on .
• All outlets are unlocked .
Initial Configuration Using the Command
Prompt
To configure the AlterPath PM, you must have a work station connected to the
console (In) port on the AlterPath PM and be logged in as the admin user. See
“Making a Direct Connection for Console Access” on page 33 for instructions
on connecting to the console. If needed, refer to Chapter 4. “Command Line
Interface” on page 49 for a description of the command line interface and
reference information on each of the commands described in the following
procedures.
Use the following procedures to perform basic configuration:
To Change the Default Password Page 39
To Create Users Using the adduser Command Page 39
To Assign Outlets to Users Using the assign Command Page 40
To Name the Outlets Using the name Command Page 40
To Save the Configuration Using the save Command Page 40