Cybex Pro+ Treadmill Service Manual
Service
Page 4-19
Locate the brush with the two wires and slide it into the motor brush holder (located nearest the
A.
round access hole).
Locate the brush with the one wire and slide it into the motor brush holder on the opposite side.
B.
Place a spring clip under each brush and push in and down. The spring hooks will grasp on to
C.
the end of the brush holder.
Using needle nose pliers, plug the yellow brush wear indicator wire onto the fast-on inside the
D.
round access hole.
Using needle nose pliers, plug each brush wire onto the fast-on inside the rectangular access
E.
hole.
14. Secure the drive motor access panels.
Squeeze each rectangular brush covers, insert it into the holes and then release.
A.
Push the round brush cover into its hole until it is fl ush with the motor.
B.
15. Align the drive motor.
Carefully lower the drive motor in position on the motor saddle.
A.
Turn the motor so the exit cable is positioned at a 3 o’clock angle toward the front roller. See
B.
Figure 16.
Using a straight-edge (such as the lower board shield), line up the face of the fl ywheel pulley with
C.
the face of the front roller pulley until they are fl ush. See Figure 11.
NOTE: Do not put the drive
belt on until step 17A.
16. Secure the motor straps.
NOTE: Tighten motor strap to 80 in-lbs.
Loop each strap through the motor saddle
A.
and position each screw vertically as shown
in Figure 16.
NOTE: The motor strap will be
creased slightly where it pressed against the
motor saddle, be sure the strap is in its original
position.
Close each motor strap and use a 7/16” wrench
B.
with a deep socket to tighten each nut securely
(80 in-lbs). See Figure 16.
Figure 16
Motor Strap
Screws
(Position
Vertically)
Motor Saddle
Nuts
Motor
Exit Wire
(Position at
3 O’clock)
Summary of Contents for Pro+
