CYBEX Pro+, Service Manual

Page: 38 / 70

Cybex Pro+ Treadmill Service Manual
Service
Page 4-10
Running Belt and Deck
NOTE: During this procedure you will have the option to remove the running deck, running belt, rubber
mounts, rear roller, front roller and drive belt. Follow this procedure from step 1 even though the
heading for some of these procedures will appear before the step where you remove that part.
Tools Required
Phillips screwdriver •
7/16” Open end wrench •
3/4” Open end or socket wrench •
9/16” Socket wrench with a 3” extension •
! WARNING: Disconnect the power cord before beginning this procedure.
1. Disconnect the external power source.
Turn the main power switch on the left side to the off (O) position. A.
Unplug the treadmill from the power outlet. B.
2. Remove the motor cover.
Using a Phillips screwdriver, loosen the three screws on each motor cover side A.
(left and right). See Figure 2.
Lift the motor cover center up and off the treadmill. B. NOTE: The screws will stay in place.
See Figure 2.
3. Remove the end caps.
Using a Phillips screwdriver, remove the screw that holds each end cap in place. A.
See Figure 4.
Figure 4
Screws
End
Caps