CYBEX Pro+, Service Manual

Page: 22 / 70

Cybex Pro+ Treadmill Service Manual
Preventive
Maintenance
Page 2-6
8. Secure the top steps.
Place each top step in position. See Figure 4. A.
Using a Phillips screwdriver, tighten the three screws that hold each top step in place. See B.
Figure 4.
9. Secure the end caps.
Using a Phillips screwdriver, tighten the screw securing each end cap in place. See Figure 3. A.
10. Secure the side panels.
Place each side panel into position slightly under the end cap and use your hand to A.
push all along the bottom edge of the side panel to snap it in place. See Figure 3.
11. Secure the motor cover.
Lower the motor cover center into position. See Figure 2. A.
Using a Phillips screwdriver, tighten the three screws on each side. Be sure the B.
screws are catching the center motor cover’s holes.
Other Preventive Maintenance
Other preventive maintenance activities must be completed by a qualifi ed service technician at the
recommended intervals listed in the Service Schedule (shown on the next page). These activities include:
Measure the motor brushes and replace worn motor brushes •
Rotate and replace the running deck •
Replace the running belt •
Check the current draw •
Measure motor voltage at maximum speed, with no load •
NOTE: See the Service chapter of this manual for detailed procedures for the maintenance activities
listed above.
Elevation Motor Lubrication — In time the elevation motor pivot points may develop a squeak.
Lubricate the upper and lower bolts and the spacers with a small amount of lithium grease. NOTE: You
can buy lithium grease at an auto parts store.
Static Electricity – Depending upon where you live, you may experience dry air, causing a common
experience of static electricity. This may be especially true in the winter time. You may notice a static
build-up just by walking across a carpet and then touching a metal object. The same can hold true while
working out on your treadmill. You may experience a shock due to the build-up of static electricity on your
body and the discharge path of the treadmill. If you experience this type of situation, you may want to
increase the humidity to a comfortable level through the use of a humidifi er. A worn running belt looses
it’s ability to dissipate static electricity and should be replaced as needed.