CYBEX Arc Trainer 630A, Service Manual

Page: 59 / 70

Arc Trainer
®
620A/629A A/V
Kit No. 620AK044
Installation Instructions
NOTE: This instruction sheet describes how to install
the Cybex Personal Entertainment Monitor on
the Arc Trainer 620A/629A .
Tools Required
• 3 mm Allen wrench (supplied with kit)
• 5/32” Allen wrench
• 7/32” Allen wrench
• 7/16” Open end wrench • Tape (step 6B)
• Phillips screwdriver • Block (step 5A)
• Utility knife
• Tape measure (step 6C)
4. Remove console assembly.
A. Using a 7/32” Allen wrench, remove the four
Button Head Socket Cap Screws (BHSCS) and
lock washers securing the console assembly.
See Figure 4.
1. Read and understand all instructions
thoroughly before installing this kit.
2. Verify kit contents.
A. Console monitor mount (1), 620A-220
B. Audio cable 1/4” to 3.5 mm 18” (1), 630A-102
C. RJ-45 round cable (1), 630A-103
D. Headphone adapter clamp (1), 630A-330
E. Headphone jack mount bracket (1), 630A-331
F. Coax and power cable I/O W/2.1 mm (1),
630A-104
G. Allen wrench 3 mm (1), BK030210
H. Adapter, 1/4 plug to 1/8 stereo jack (1),
ES000001
I. Self tapping screw 8-16 x .31 (2), HT552509
J. Self tapping screw 8-16 x .75 (2), HT552515
K. Strain relief bushing (1), PP740000
L. A/V bottom membrane (1), SW-19295-4 ( NOTE:
for English Console only)
M. Cybex monitor kit (1), EE000005 or EE000007
N. Poster (1), 620A-387 (not shown)
O. Warranty sheet (1), LT-20219 (not shown)
P. Cable Tie (2), EW000028
Figure 2
Q
R
S
T
U
V
W
X
Y
3. Verify monitor kit contents shown in Figure 2.
Q. Monitor (1), EE000005 or EE000007
R. Remote control (1), EM000000
S. Batteries, remote control, AAA size (2), N/A
T. Screws, mounting, M4 x 0.7 x 10 mm (4),
HC692860
U. Washers, external lock, (4), HS047300
V. Washers, flat, M4 (4), HS097600
W. AC/DC adapter (1), ET300038
X. Power cord, 115 VAC 60 Hz, (Country
specific cords supplied with product), (1),
EW600000
Y. Personal Entertainment Monitor Manual (1),
LT-20191
Figure 1
M
F
B
C
L
K
H
D
E
I
J
A
G
P
NOTE: The Power Cable of (F) has a male and female
connector at either end. Make sure the female
end goes to the Monitor (Q) and the male end
is at the base. See Figure 3.
Figure 3
Male
Connector
Female
Connector