CYBEX Arc Trainer 630A, Service Manual

Page: 24 / 70

7. Remove the left shroud (600AK025).
A. Remove the ten screws and two washers
securing side cover in place.
9. Replace cover inserts (if applicable).
A. Using a Phillips head screwdriver, remove the
screw securing cover insert (item D) to shroud
and remove cover insert.
B. Install new cover insert.
C. Using a Phillips head screwdriver, install screw
removed in step A and tighten securely.
10. Install left shroud (600AK025).
A. Place left shroud in position on the cover inserts.
B. Using a Phillips head screwdriver, install the ten
screws and two washers securing the side cover.
See Figure 4
C. Securely tighten all screws.
11. Install right shroud (600AK027).
A. Place right shroud in position on the cover inserts.
B. Using a Phillips head screwdriver, install the ten
screws and two washers securing the side cover.
See Figure 5.
C. Securely tighten all screws.
12. Reinstall linkage arm.
A. Place a small amount of loctite (item I) to threads
of SHCS removed in step 6A and place anothe
r
drop of loctite into the shaft (where the SHCS will
be tightened into).
B. Using a 3/16” Allen wrench, reinstall the parts
removed in step 6A. See Figure 3.
C. Torque to 100 in. lbs.
13. Reinstall access cover.
A. While being sure not to pinch any cables, hold
the access cover in place. See Figure 2.
B. Using a Phillips head screwdriver, install and
tighten the two upper screws first (removed in
step 5B).
NOTE: Do not over tighten screws.
C. Install and tighten the two lower screws
(removed in step 5A). NOTE: Do not over
tighten screws.
14. Test unit for proper operation.
Figure 3
SHCS
Flat washer
Cap
Spacer
Linkage Arm
B. Lay the linkage arm down on the frame.
NOTE: Place a cloth or rag in between
the linkage arm and the frame to prevent
scratches.
C
H
G
F
E
C
F
F
F
D
D
B
8. Remove the right shroud (600AK027).
A. Remove the ten screws and two washers
securing side cover in place.
C
H
G
F
C
F
F
F
D
D
A
H
Figure 4
Figure 5
Cybex® and the Cybex logo are registered trademarks of Cybex International, Inc.
Arc Trainer® and its mark are registered trademarks of Cybex International, Inc.
10 Trotter Drive Medway, MA 02053 • 508-533-4300 • FAX 508-533-5183 • www.cybexinternational.com • techhelp@cybexintl.com
techpubs@cybexintl.com • Copyright © 2008, Cybex International, Inc. All rights reserved • 600A-357 B • March 2008