![background image](http://html1.mh-extra.com/html/cybex/600t/600t_service-manual_2703701038.webp)
Cybex SOOT Treadmill Service Manual
C
Plug the cable connections into the
lower control board. This includes
the power in, drive motor, elevation
motor, speed sensor, brush wear
indicator and display cables. The
white wire connects to the terminal
"AC NEUT" or "L1" on the 220V. The
black wire connects to the terminal
"AC L1NE" or "L2" on the 220V. See
Figure 11.
D. Arrange the display cable in a
service loop. See Figure 13.
E.
Attach the lower board shield.
Figure 13
5. Attach the motor cover.
A.
Place the rear of the motor cover in the rear guide holes.
B.
Lower the front end of the motor cover and install the two Phillips head screws
that hold it in place.
Power Cables
Tools Required
• Phillips head screwdriver
NOTE:
This procedure will cover the power cables, line filter, power switch and power
cord inlet.
Tools Required
• Phillips head screwdriver
1. Turn the power off.
A.
Turn the main power switch in the front panel to the off (0) position.
B.
Unplug the treadmill from the power outlet.
Power
Inlet
Power
Switch
B.
Lift the cover from the front and remove it from the
treadmill. Set the cover and screws aside. See Figure 1.
2. Remove the motor cover.
A.
Remove the two Phillips head screws that fasten the motor
cover to the frame.
3. Remove the power cables.
Figure 14
Page 5-16
Summary of Contents for 600T
