CYBEX 600T, Service Manual

Page: 27 / 55

Cybex 600T Treadmill Service Manual
C. The running belt is now free to remove from the treadmill.
NOTE:
If
you are reusing the same belt be sure to note which way the
belt is positioned before removing it from the treadmill. The
directional arrow inside the belt may have rubbed off. Make
a
new
arrow if needed.
! CAUTION: Do not use
a
running belt made for
a
different model
treadmill. The belts are specific for each treadmill and
may be torn up or cause excessive current and damage
the electronics if used in combination with another deck.
Running Belt
9. Position the running belt and running deck.
A. Locate the directional arrow stamped on the inside of the belt. The
arrow should point the direction of travel. See Figure 7. Place the
running belt in position.
B. Place the deck in position with the wax side up and then continue
with step 10.
Front Roller
10. Attach the front roller.
A. Slide the front roller into the running belt. Be sure the drive belt is
around the fly wheel drive pulley and the front roller before attaching
the front roller.
B. Loosely attach the two bolts and four washers that fasten the front
roller to the front end assembly. See Figure 6.
C. Tighten each of the two bolts evenly. Make sure not to tighten one
bolt too many turns before moving to the other bolt.
Table of Contents
i
Read All Instructions
&
Warnings
ii
Important Safety
iv
About This Manual
Important Voltage Information. iv
FCC Compliance Information
. iv
V
Dec l aration of Confonnity
vii
Table of Contents
1
Safety
Warning DecaJs . . . . . . . . . .. 1-1
Caution DecaJs . . . . . . . . . .. 1-2
2
Technical Specifications
Specifications 2-1
3
Preventative Maintenance
Regular Maintenance Activities 3-1
Running Belt Maintenance.. 3-3
4
Troubleshooting
Test Mode 4-1
LED Functions. . . . . . . . . . . 4-1
Key Functions . . . . . . . . . .. 4-2
Error Codes. . . . . . . . . . . .. 4-2
Speed Sensor Adjustments. 4-3
5
Removal & Replacement
Running Deck . . . . . . . . . . .. 5-1
Running Belt . .. . . . . . . . . .. 5-5
Roller . . . . . . . . . . . . . . 5-5
Drive Belt. . . . . . . . . . . . . . .. 5-5
Rear Roller. . . . . . . . . . . . . .. 5-6
Drive Motor. . . . . . . . . . . . .. 5-7
Motor
Brush . . . . . . . . . . ..
5-10
Elevation Motor 5-13
Lower Control
Board
5-15
Power Cables 5-16
Une Filter 5-17
Power Switch 5-17
Power
Cord
Inlet 5-18
Display Board 5-18
Heart Rate Board 5-20
Lower Display
Board
5-21
Polar
Board
5-21
Upper Display
Cable
5-22
Lower Display Cable 5-24
Display Overlays 5-25
6
Diagrams
Parts Ust . . . . . . . . . . . . . .. 6-1
Exploded 6-3
600T Schematic 6-4
7
Customer
Service
Contacting Service . . . . . . .. 7-1
Serial
Number &
Voltage ... .
7-1
Retum Material Authorization
(RMA) 7-1
Damaged Parts.. . . .. .. 7-2
8
Index 8-1
Page 5-5