Installing the VoIP Intercom
Intercom Setup
Operations Guide
930242A-D
CyberData Corporation
34
2. On the
Network Configuration
page, enter values for the parameters indicated in
Table 2-8
.
3. You must click on the
Save
button and then the
Reboot
button for the changes to take effect.
Table 2-8. Network Configuration Parameters
Web Page Item
Description
Stored Network Settings
IP Addressing
Select either
DHCP
IP Addressing
or
Static IP Addressing
by
marking the appropriate radio button. If you select
Static
,
configure
the remaining parameters indicated in
Table 2-8
. If you select
DHCP
,
go to
Step 3
.
IP Address
Enter the Static IP address.
Subnet Mask
Enter the Subnet Mask address.
Default Gateway
Enter the Default Gateway address.
DNS Server 1
Enter the DNS Server 1 address.
DNS Server 2
Enter the DNS Server 2 address.
VLAN ID (0-4095)
Enter the VLAN ID number.
Note
: The device supports 802.11Q VLAN tagging support. The
switch port connected to the device will need to be in “trunking mode”
for the VLAN tags to propagate.
VLAN Priority (0-7)
Enter the VLAN priority number.
DHCP Timeout
DHCP Timeout in seconds
Enter the desired timeout duration (in seconds) that the device will
wait for a response from the DHCP server before defaulting back to
the stored static IP address.
Note
: A value of
-1
will cause the device to retry indefinitely and a
value of
0
will cause the device to reset to a default of 60 seconds.
Current Network Settings
Shows the current network settings.
IP Address
Shows the current Static IP address.
Subnet Mask
Shows the current Subnet Mask address.
Default Gateway
Shows the current Default Gateway address.
DNS Server 1
Shows the current DNS Server 1 address.
DNS Server 2
Shows the current DNS Server 2 address.
Click the
Save
button to save your configuration settings.
Note
: You need to reboot for changes to take effect.
Click on the
Reboot
button to reboot the system.